COLOMBIA
CAN-BUS RELAY

CAN-BUS RELAY

[N1003-CR]
IN STOCK

Make / Model Universal - Indicators

$29.00 GST Incl.

Qty:
Description
The CAN-BUS RELAY BARRACUDA is an electronic component essential for the correct operation and flashing of the direction indicators relating to most vehicles equipped with the CAN-BUS system.

The CAN-BUS RELAY supplies an electrical load necessary for the correct operation and flashing of the BARRACUDA LED INDICATORS through the combination of the appropriate switches.

It is possible to operate up to 2 channels, for example: the direction indicators in the Rear Left and direction indicators in the Rear Right.

The CAN-BUS RELAY BARRACUDA can also be used on vehicles equipped with original LED direction indicators.

The following resistance values ​​can be set:
150 ohms
170 ohms
200 ohms 240 ohms 300 ohms 400 ohms 600 ohms
1200 ohms

Cable length = 200mm with 3mm Faston

Connections:
Yellow = channel 1 input (+)
Orange = output channel 1 (+)
Blue = input channel 2 (+)
Red = output channel 2 (+)
Gray = input mass (-)
Black = exit surface (-)

Connectivity: 1 CAN-BUS REALIS for 1 PAIR of INDICATORS.

The CAN-BUS RELAY BARRACUDA is an electronic component essential for the correct operation and flashing of the direction indicators for most vehicles equipped with the CAN-BUS system.
The CAN-BUS RELAY supplies an electrical load necessary for the correct operation and flashing of the BARRACUDA LED INDICATORS by means of the combination of the appropriate switches.
Up to 2 channels can be operated, for example: direction indicators in the Rear Left and direction indicators in the Rear Right.
The CAN-BUS RELAY BARRACUDA can also be used on vehicles equipped with original LED direction indicators.
The following resistance values ​​can be set: 150 ohm 170 ohm 200 ohm240 ohm300 ohm400 ohm600 ohm 1200 ohm Cable length = 200mm with 3mm Faston Connections: Yellow = channel 1 input (+) Orange = output channel 1 (+) Blue = input channel 2 (+) red = output channel 2 (+) gray = input ground (-) black = output surface (-)
Connectivity: 1 CAN-BUS REALIS for 1 PAIR OF INDICATORS.

This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.
x